| 编号 | 中文名称 | 英文名称 |
|---|---|---|
| ANSI/AISI/COS TS-6-2004 | 板式和锚式结构试验标准程序 | Standard Procedures for Panel and Anchor Structural Tests |
| ANSI/API SPEC2F-1997 | 系泊锚链 | Mooring Chain |
| ANSI/ASTM E754-1980 | 埋入砌筑砂浆缝中的拉杆和锚的拉拔阻力的试验方法 | Test Method for Pullout Resistance of Ties and Anchors Embedded in Masonry Mortar Joints (04.11) |
| ANSI/ASTM E894-1988 | 建筑物护栏和永久金属护栏系统用锚固装置的试验方法 | Test Method for Anchorage of Permanent Metal Railing Systems and Rails for Buildings (04.11) |
| ANSI/ASTM F765-1993 | 锚链轮规范.船锚链 | Specification for Wildcats, Ship Anchor Chain |
| ANSI/ASTM F936-1997 | 巴拿马锚用铸钢轮挡规范 | Specification for Chocks, Panama, Mooring Cast Steel |
| ANSI/ASTM F937-1997 | 船锚用铸钢轮挡规范 | Specification for Chocks, Ship Mooring, Cast Steel |
| ANSI/SAE J1369-1997 | 后座儿童减震系绳搭板锚固规定 | Anchorage Provisions for Installation of Child Restraint Tether Straps in Rear Seating Positions |
| ASTM A 981-1997 | 评估预应力地下锚定装置用270级未涂覆15.2mm(0.6in)直径预应力钢绞线结合强度的标准试验方法 | Standard Test Method for Evaluating Bond Strength for 15.2 mm (0.6 in.) Diameter Prestressing Steel Strand, Grade 270, Uncoated, Used in Prestressed Ground Anchors |
| ASTM C 1242-2005 | 规格石锚固系统的选择、设计和安装的标准指南 | Standard Guide for Selection, Design, and Installation of Dimension Stone Anchoring Systems |
| ASTM D 4435-2004 | 石栓锚定拉力试验的标准试验方法 | Standard Test Method for Rock Bolt Anchor Pull Test |
| ASTM E 1512-2001 | 测试粘接的锚的粘结性能的标准试验方法 | Standard Test Methods for Testing Bond Performance of Bonded Anchors |
| ASTM E 2265-2007 | 混凝土和砖石工程用锚和紧固件的标准术语 | Standard Terminology for Anchors and Fasteners in Concrete and Masonry |
| ASTM E 488-1996 | 混凝土及砌块构件中锚定强度的试验方法 | Standard Test Methods for Strength of Anchors in Concrete and Masonry Elements |
| ASTM E 754-1980 | 埋入砖石灰缝中的拉杆和锚的拔拉阻力的标准测试方法 | Standard Test Method for Pullout Resistance of Ties and Anchors Embedded in Masonry Mortar Joints |
| ASTM E 894-1988 | 建筑物用永久性金属围栏系统及围栏的锚定试验 | Standard Test Method for Anchorage of Permanent Metal Railing Systems and Rails for Buildings |
| ASTM F 1554-2007 | 屈服应力为36、55和105ksi的钢制锚固螺栓用标准规范 | Standard Specification for Anchor Bolts, Steel, 36, 55, and 105-ksi Yield Strength |
| ASTM F 2437-2006 | 与螺旋帽、螺栓、锚和螺柱用碳和合金钢可压缩垫圈式直读张力指示器的标准规范 | Standard Specification for Carbon and Alloy Steel Compressible-Washer-Type Direct Tension Indicators for Use with Cap Screws, Bolts, Anchors, and Studs |
| ASTM F 765-1993 | 船用锚链及锚链轮 | Standard Specification for Wildcats, Ship Anchor Chain |
| ASTM F 936-1985 | 巴拿马铸钢船锚塞块 | Chocks, Panama, Mooring Cast Steel |
| ASTM F 937-1985 | 铸钢船锚塞块 | Chocks, Ship Mooring, Cast Steel |
| 编号 | 中文名称 | 英文名称 |